Press to select the flat-edge finish.
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing (F p.67) and Edging a
lens > Perform a chamfering (F p.67).
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The edging cycle starts.
When the edging cycle is finished, the retouch screen is displayed.
Press to release the lens.
If necessary, retouch the lens.
Otherwise, start edging the second lens. Select the lens directly on the screen, on the left or right of the
work area.
The edging screen for the second lens is displayed. All finishes chosen and the modifications made
are kept.
7. DO A MIXED JOB
In this section, you will find the required procedure to do a mixed job:
• Description of menu screens (F p.58)
• Configuring the mixed finish (F p.60)
This finish enables you to do mixed jobs such as the following:
• Groove - Groove
• Bevel - Groove
• Flat-edge - Groove
• Flat-edge - Bevel
To Next Page
Loading...
Need help?
General