3. DECLARATION OF CONFORMITY
Complies with marking:
EurAsia Conformity :
Complies with ISO 16284 standards, IEC 61010-1 and IEC 61326-1 and with directives 200/42/CE, 2014/30/UE, 2014/35/UE.
This equipment complies with the limits imposed by Part 15 of the FCC rule. Its use meets the following conditions: (1) this device must not
cause interference and (2) must accept interference from external sources, notably that liable to cause malfunctions.
In accordance with the requirements of FCC rules, any modification made to this equipment which is not expressly approved by ESSILOR
INTERNATIONAL would nullify the user's right to use this device.
This equipment has been tested and is deemed compliant with the limits imposed for Class-B digital devices according to Part 15 of the FCC
rule. Those limits are set so as to ensure reasonable protection against interference in a residential environment. This equipment generates,
uses and may emit radiofrequency energy liable to interfere with radio communications if the device is not installed and used in strict
compliance with manufacturer instructions. However, nothing guarantees the absence of interference under particular conditions. If this
equipment is the source of interference with radio or television reception (this can be confirmed by switching off the device then turning it
back on), the user may be able to eliminate this interference through one or more of the following measures:
• Swivel of move the affected receiver or its receiving antenna;
• Move the device away from the affected receiver;
• Connect the device to a different circuit to that powering the affected receiver;
• Request help from the retailer or a qualified radio / television technician.
4. COPYRIGHT
Copyright © 2018 Essilor - Original manual
All rights reserved. All reproduction of the content of this document, whether in part or as a whole, for the purpose of its publication or
dissemination by any means and in any format whatsoever, even free of charge, is strictly prohibited without Essilor's prior written consent.
5. MATERIALS AND PRODUCTS
All edgers obtain a final shape on a lens, by removing material. This process generates dust, which depends on the lens and the materials
used.
The materials used for coating the Essilor wheel and consumed during its use are not toxic or allergenic. Nevertheless, users must check
that the ground materials are not toxic.
The edger significantly limits dust emissions due to its integrated devices: operation in a closed machine and edging in a wet environment.
Do not place this machine in a dusty environment, in a room where the temperature is too high or too low, or in a wet place.
6. SAFETY INSTRUCTIONS:
All mechanical or electronic adjustments and electrical maintenance must be carried out by a customer service technician approved by
Essilor.
The use of an accessory or a cable other than those recommended in this manual can be dangerous for users.
Keep the power cables and the solenoid valve/pump cables away from sources of heat, sharp objects and grease.
Check the power cable regularly; if damaged, have it replaced by an approved repairer.
Do not use your system in any way other than described in this document. Otherwise, the protection provided by the device could be
compromised.
Never try to modify or dismantle this product yourself. In addition to the fact that you are likely to damage the instrument, you can also
injure yourself.
Your device must be carefully maintained, in accordance with the instructions detailed in this document.
To Next Page
Loading...
Need help?
General