Your system is an electrical appliance compliant with the applicable safety standards. In the event of malfunction, repairs must be carried
out by qualified personnel approved by Essilor. Otherwise, user safety is likely to be compromised.
In the event of a long period of non-use and before maintenance and/or replacement of certain accessories, you must unplug your system
from the mains.
The equipment must be plugged into an earthed power supply. The earth connection must comply with public standards and be checked by
a technician. Avoid using extension cables or adaptors which could create a poor contact.
Never pull on the cables to unplug them from the power socket.
Before plugging your device into the mains, make sure that the switch is in the OFF or 0 position.
If the switch no longer operates ON/OFF (0/I) you must stop using your digital system. Defective switches must be replaced by an approved
repairer.
Your system is a professional tool which must only be used by specialized, responsible operators. It must not be used by anyone apart from
these operators.
This machine is neither adapted nor intended to operate in an environment where there is a risk of explosion. Do not use this system in the
presence of liquids or flammable gases.
Make sure that the equipment is connected to a mains supply which complies with standard NFC 15-100. In addition, make sure that the
plug type is 3-pin 10/16 A (earthed) protected by a high sensitivity differential circuit-breaker, maximum 30 mA, and that the wall outlet is
easy to access.
The opening of covers is strictly reserved for maintenance. Do not have the machine operate in normal usage with one or more cover open.
It is strongly advised to wear gloves to protect your hands when you empty the tank to clean it.
7. ELECTROMAGNETIC WAVES
Electromagnetic waves emitted by television sets or radios, mobile phones, radio transmitters, etc. are liable to cause malfunctions in the
instrument. This instrument is also liable to interfere with television sets or radios, mobile phones, radio transmitters, etc. Avoid installing or
positioning devices which may create interference near the instrument. Likewise, never place the instrument on or near this type of device.
This could generate malfunctions or faults in the instrument.
Interference and micro-outages
The products have been designed to withstand interference and operate despite its presence and the possibility of micro-outages on the
network.
However, if these malfunctions are too serious and abnormal, the machine cannot be guaranteed to operate normally.
8. LICENSE AGREEMENT FOR M’EYE SIGN™ (ENGRAVING) SOFTWARE
Please read this licence agreement closely before using the m’eye sign™ software, by using this software, you acknowledge being bound by
the terms of this licence, unless otherwise agreed. If you disagree with the terms of this license, do not use the software.
a. General information
Essilor International (hereafter called “Essilor”) grants you a license for use of its M’Eye Sign™ software exclusively for the use set out in
these terms and conditions. Essilor reserves all rights which are not expressly granted to you. Rights granted by the terms of this license
and its updated version (available at the following address: http://www.mleiyceesnicgen.com/fr), apply to possible software updates used
to replace and/or complete and/or correct the original M’Eye Sign™ software (hereafter “Software”), unless these updates have a separate
license.
You acknowledge having been informed that the installation of the M’Eye Sign™ software requires an internet connection. Essilor does not
guarantee that the connection will be uninterrupted and does not guarantee that it will work or the quality of the connection.
To Next Page
Loading...
Need help?
General