The wheel is installed.
When replacing a chamfering wheel with a step bevel wheel, or cleaning the machine, the
statistics will be saved by default.
>The icon appears by default at the bottom of the screen.
In case of replacement:
• of the chamfering wheel with a new step bevel wheel: you must press to reset
the statistics to 0.
The icon appears, the statistics are cleared.
• of the step bevel wheel with a new chamfering wheel: you must press to reset
the statistics to 0.
The icon appears, the statistics are cleared.
Press to confirm the tool change, then to exit the menu.
e. Installing and changing the engraving tip
From the edger work screen, select > > to clean, change or install the engraving tip.
The wear indicator tells you when you need to change the engraving tip after every 50,000 mm (5
km).
When an engraving is uneven, you may need to change the engraving tip: refer to your customer
service technician.
Prerequisite:
You must have the following tools:
To Next Page
Loading...
Need help?
General