Essilor Pro-E 700 edger User Manual

Press to confirm the shelf bevel.
b. Finalize the step bevel settings in “front surface follow-up” mode
Configure the flat side of the bevel and the front shelf bevel of the bevel step.
Press the buttons and on the right of your screen to modify the width of the flat side of the bevel.
The result can be viewed in the zoom window.
Press the buttons and on the right of your screen to modify the value of front surface tracking.
It is advised to set the value at 0 because front shelf bevel will be viewable on the entire contour
of the shape.
>
7
1
2
3
Pro-E 600_Pro-E 700 > v1 -10.18
94
USER MANUAL> II. EDGING A LENS

Essilor Pro-E 700 edger Specifications

General

Brand	Essilor
Model	Pro-E 700 edger
Category	Laboratory Equipment
Language	English