Search LOC / Search NET
Once the search criteria are defined:
• Use the Srch Loc command (press the C key) to search the local clips database.
• Use the Srch Net command (press the D key) to search the entire network database.
The matching clips are the ones that contain all keywords used as search criteria, and that
have at least the requested ranking.
If matching clips are found, the remote will automatically be in Browse mode (the Browse
key is red), allowing the operator to quickly view the Short IN of each clip corresponding to
the search criteria by rotating the jog dial.
To jog inside a clip:
• Press the Browse key to disable the Browse mode.
• Move the jog dial.
• To return to the Browse mode inside the search results, press the Browse key again.
Notes:
• Search results are reset when going by to Live mode, or when a new search is
performed.
• If no matching clips are found, a message notifies the operator.
Adding the Search Results to the Current Playlist
To directly add all search results (clips only) to the current playlist:
• Press ENTER on the selected clip to insert only that one.
• Press SHIFT+ENTER to insert all clips at the end of the current playlist.
Search Reset
To Reset the search criteria, press SHIFT+A. The default values of the search criteria (no
from/to date) are reset and the default TC is set to the loaded TC on the PGM.
OPERATION MANUAL Multicam LSM 12.05
7. Keyword Management 167
To Next Page
Loading...
Need help?
General
