How to Use Speedbreak
1. Make sure the Speedbreak mode is active on the Remote Panel (See section "LCD
Menu on the Remote Panel" on page 205).
2. Call a sequence back by pressing the CAM key of the requested block (for example).
Previously introduced IN/OUT points are not taken into account when you are playing
the sequence with the jog.
3. Jog in the sequence and define an IN point (compulsory) and an OUT point (optional)
with the IN and OUT keys.
If required, delete these points using the CLEAR + IN/OUT keys.
4. Start the replay using the PLAY button or the lever.
◦ If a speed is defined on the Remote Panel, the replay starts at this defined speed.
◦ If not, the replay starts at PGMSpeed.
The replay in Speedbreak mode is thus performed at the following speed
• Before the IN point: speed defined on the Remote Panel or PGMSpeed.
• Between the IN and the OUT points: nominal speed.
• After the OUT point: speed defined on the Remote Panel or PGMSpeed.
Managing IN and OUT Points
When the Speedbreak functionality is active:
• IN and OUT points are displayed on the OSD of the hypermotion recorder.
• IN and OUT points are memorized per block.
• IN and OUT points are deleted when:
◦ A block is recorded again.
◦ The number of blocks is modified.
◦ The configured connection type or port is modified.
◦ Multicam is restarted.
212 9. Advanced Control Modes
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
