Possible Actions on Cue Points
Adding Cue Points
To add a cue point, press the Mark key.
• If Mark cue point is set to Playback, the cue point is added on the current clip.
• If Mark cue point is set to Live, the cue point is added on the record train of the PGM
recorder.
Deleting Cue Points
To delete a single cue point, proceed as follows:
1. Go to the cue point.
2. Press the CLEAR + Mark keys.
To delete all cue points, proceed as follows:
1. Make sure you are not on a cue point.
2. Press the CLEAR + Mark keys.
Browsing Through Cue Points
To go to the previous available cue point, press the Last Cue key.
• If a preroll value is set, the PGM goes to the previous cue point minus the preroll
duration.
• If the timecode of the previous cue point minus the preroll duration happens before
Protect IN, the PGM goes to the Protect IN point.
• The previous cue point is loaded with the same camera angle as when it was defined.
If this makes a duplicate of a camera angle that is displayed on another controlled
PGM, the camera angles are swapped between both PGMs.
To browse through the cue points, proceed as follows:
1. Make sure the Browse parameter is set to Browse.
2. Make sure cue points are defined on the current clip or record train.
3. Press the Browse key to browse through the cue points of the clip or record train.
OPERATION MANUAL Multicam LSM 12.05
4. Clip Management 73
To Next Page
Loading...
Need help?
General
