Freezing on a Specific Image
To freeze on a specific image, proceed as follows:
1. Make sure the Freeze on cue points parameter is set to Yes in the Multicam
Configuration module.
2. Add a cue point on the image you want to freeze on.
3. Go to that cue point.
If a cue point is located between OUT point and OUT point + PostRoll, the playout does
not freeze on the OUT point but on the cue point; and then on the OUT+ PostRoll.
If a cue point is located after the OUT + PostRoll, the playout freezes on the OUT +
PostRoll, and then on the cue point.
This feature is required for the Epsio.Zoom functionality.
Cue Point Behavior
• Cue points are managed only using the LSM Remote Panel.
• Cue points are stored in the LSM Remote RAM memory, so they can be used only
locally on the LSM Remote and are lost whenever Multicam is stopped.
• During local clip copy, the cue points associated to the clip are also copied.
• During remote clip copy, the cue points associated to the clip are not copied.
• During clip creation, all cue points existing on the record train between Protect IN and
Protect OUT points are stored along with the clip in Multicam.
• A maximum of 32 cue points can be stored per clip:
◦ If more than 32 cue points are defined on the portion of the train being clipped, only
the last defined 32 cue points are copied to the clip.
◦ When a clip has 32 cue points defined, additional cue points delete the oldest
ones.
• When a clip or a record train is loaded, the Mark key color on the LSM Remote is:
◦ Off: No cue points are defined.
◦ Green: At least one cue point is defined.
◦ Red: The PGM is located exactly on a cue point.
74 4. Clip Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
