3 Copy
102
Copy
3
îš„Variable Size
Enter the desired scan size when scanning a non-standard size document or when
making copies at a size different from the original document size. You can specify a
value in the range from 15 to 432 mm for the width (X), and a value in the range from
15 to 297 mm for the length (Y), in 1 mm increments. To help you specify values, use
the scales attached on the upper and left edges of the document glass.
Important • When a document is loaded in the document feeder, the base point in the Y (length)
direction is the center of the edge. If you specify 100 mm, the scan length will be from 50 mm
above to 50 mm below the center of the document.
Mixed Size Originals (Scanning Different Size Documents Simultaneously)
You can scan documents of various sizes simultaneously and make copies of the
corresponding sizes or of one selected size. To use this feature, load the documents in
the document feeder.
Important • Load documents in landscape orientation. However, always load A5 documents in portrait
orientation.
• When loading B5 documents together with A3 documents loaded in landscape orientation or
A4 documents loaded in portrait orientation, load B5 documents in portrait orientation.
• If the top left corners of the documents are not aligned properly, the documents may not be
scanned correctly.
• The recommended document size combinations are A4 portrait and A3 landscape, or B5
portrait and B4 landscape. If another combination of document sizes is used, the documents
can be fed at an angle and may not be copied properly.
1 Select [Mixed Size Originals].
2 Select [On].
îš„Off
Select this option when copying documents of the same size.
îš„On
When documents of different sizes are copied, the machine automatically detects the
size of each document.
îš„Original Orientation
Allows you to specify the orientation of the document so that the machine can identify
the top of the document.
Note • The [Original Orientation] setting is based on the orientation of the first page of a document.
Load the second and subsequent pages of the document based on this setting.
• If the [Original Orientation] setting differs from the actual document orientation, the machine
may not detect the top of the document correctly.
To Next Page
Loading...
Need help?
General
