Fuji Xerox ApeosPort-IV 3070 User Manual

5 Scan
298
Scan
5
6 The [Store to WSD - Remove Your Originals]
screen appears on the touch screen after a
scan job has been completed. Remove the
originals from the document glass or the
document feeder, and then click [OK].
Note • If the standby screen is not displayed, a scan job will not be started even when the network
computer recognizes the machine.
• Select the [Delete] button to abort an operation. After an operation is aborted, the [Store to
WSD - Remove Your Originals] screen is displayed on the touch screen.
• The machine will not enter the Energy Saver mode while the standby screen is displayed.
For information on Energy Saver mode, refer to "Energy Saver Mode" (P.57).
This Device (Storing Data Scanned by the Machine on a Network Computer)
You can forward the data scanned with the command from the machine to a specified
computer on the network.
1 Load the document on the document glass
or in the document feeder, and select [This
Device].
2 Computer names and 5 processing methods
are displayed in the [List of Computers].
Select destination from the list in accordance
with the intended use.
List of Computers
Lists destination and URL.
Note • Select from among 5 kinds of processing methods (Scan to PC, Scan for Print to PC, Scan
for E-mail to PC, Scan for Fax to PC, Scan for OCR to PC) in accordance with the intended
use.
3 Press the <Start> button.
123
4
56
789
0#
C
<Start> button

Fuji Xerox ApeosPort-IV 3070 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-IV 3070
Category	Copier
Language	English