10 Media Print (Text)
360
Media Print (Text)
10
Inserting USB Memory Device
1 Insert the USB memory device into the USB memory slot on the control panel.
2 One of the following occurs.
z
The [USB Device Detected] screen appears.
z
The [Store to USB] screen appears.
z
The [Media Print - Text] screen appears.
z
The screen display does not change.
Note • The behavior depends on the settings. Ask your system administrator for more information.
• When a USB memory device is inserted into the USB memory slot during Energy Saver
mode, the touch screen does not light up. After exiting Energy Saver mode by pressing the
<Energy Saver> button, insert the USB memory device again or select the [Store to USB] on
the [Services Home] screen. For information on other ways to exit Energy Saver mode, refer
to "Exiting Energy Saver Mode" (P.58).
• The screen status will be one of the above even when a USB memory device in which only
encrypted data is stored is inserted or a USB memory device in unsupported format is
inserted. In such cases, a warning message appears during operation and the operation is
aborted.
• The screen status will be one of the above when a commercially available Memory Card
Reader is inserted into the USB memory slot of the machine. It is the same if no media is
inserted into the Memory Card Reader.
• If a commercially available Memory Card Reader is used and left inserted all the time, the
machine will not detect media even when it is inserted into the slot of the Memory Card
Reader.
• The screen display remains the same when the inserted USB memory device or Memory
Card is removed. Press the <Services Home> button or perform another operation to
change the screen display before starting the next operation.
When the [USB Device Detected] Screen Appears
1 Select [Media Print - Text].
2 The [Media Print - Text] screen appears.
To Next Page
Loading...
Need help?
General
