Output Format
135
Copy
3
Copy Output (Specifying Finishing Options)
This feature allows you to select finishing options.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
If the finisher is installed, each set of copies can be stapled, and then output. When the
Hole Punch Kit for Finisher-B1, the Finisher-C1, or the Finisher-C1 with Booklet Maker
is installed, holes can be punched in the copies.
1 Select [Copy Output].
2 Select any option.
îš„Auto
Copies are collated when the originals are
loaded in the document feeder.
Copies are collated when originals are loaded on the document glass and any of the
following features is used: 2 Sided Book Copying, Covers, [Blank Separators &
Handouts] or [Transparency Set & Handouts] of Transparency Options, Booklet
Creation, Stapling, Build Job, Sample Set, and Combine Original Sets.
îš„Collated
The machine outputs sheets sorted into sets that are arranged in page order.
îš„Uncollated
The machine outputs the specified number of copies and sorts sheets by page.
îš„Uncollated with Separators
The machine outputs copies with blank sheets inserted as a separator and sorts sheets
by page.
When [Bypass] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.90).
îš„Separator Tray
When you select [Uncollated with Separators], select the paper tray to be used for the
separators.
Note • When you use the bypass tray, select [Bypass] on the [Paper Supply - Separator] screen.
CAUTION
z
Waste staples may come out with output paper. Be careful not to get injured by the
staples.
z
Do not staple punched holes of paper. Sharp points of a staple may cause injuries.
To Next Page
Loading...
Need help?
General
