Fax/Internet Fax Options
207
Fax
4
Starting Rate (Selecting a Communication Mode)
You can select a communication mode based on the features of the remote machine.
G3 is the international standard for fax transmissions established by the ITU-T.
When you use speed dialing, one touch buttons, group dial number or the address book to specify a
recipient registered in an address number, the communication mode currently set to the address number
is set and cannot be changed. For information on how to register address numbers, refer to "5 Tools" >
"Setup" > "Add Address Book Entry" in the Administrator Guide.
You can change the default mode of [Starting Rate] in System Administration mode. For information on
how to change the default mode, refer to "5 Tools" > "Fax Service Settings" > "Fax Defaults" >
"Starting Rate" in the Administrator Guide.
Note • [G4 Auto] is displayed when the Internet Fax Kit (optional) is installed.
1 Select [Starting Rate].
2 Select any option.
îš„G3 Auto
Select this mode if the remote machine is G3 compatible. This mode is normally
selected.
Depending on the reception capabilities of the remote machine, the machine
automatically switches modes in the following order: G3 Unique ECM J G3 Unique J
ITU-T G3 ECM J ITU-T G3.
îš„Forced 4800 bps
Select this mode when transmitting over noisy or poor telephone lines, as can be the
case with overseas calls.
Also select this mode when transmitting over noisy or poor telephone lines
domestically.
îš„G4 Auto
[G4 Auto] is displayed when the Internet Fax Kit (optional) is installed. This setting is
applied to the transmission speed between the fax gateway and destination fax for the
Internet Fax.
About Forced 4800 bps
You can communicate with faxes overseas via telephone company exchanges, etc.
Note • International telephone networks are originally designed for voice communications. Noise
that does not really affect voice communications causes a problem with fax communications.
It may result in the deterioration of images quality, the inability to transmit a fax, or even
terminate the transmission. Regardless of whether transmission is successful, you are
charged for the call once the line is connected. For information on line trouble and call
charges, contact your telephone company.
To Next Page
Loading...
Need help?
General
