Fuji Xerox ApeosPort-IV 3070 User Manual

Copying Procedure
73
Copy
3
1 Remove any paper clips and staples before loading a document.
2 Load the document face up (when the
document is 2-sided, load the front side up)
in the center of the document feeder.
Note • The confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, load the
document again.
3 Adjust the document guides to match the
size of the document loaded.
4 Raise the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying the Scan Size for the Document)" (P.101).
The standard document sizes that can be detected automatically depend on the [Paper Size Settings]
made in System Administration mode. For information on the paper size settings, refer to "5 Tools" >
"Common Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
Confirmation indicator

Fuji Xerox ApeosPort-IV 3070 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-IV 3070
Category	Copier
Language	English