z
[Output Color], [Reduce/Enlarge] and [Paper Supply] cannot be specified.
2
From [Frequently Used Features] on the right of the screen, select a button and the position
of the button where you want to allocate a feature.
z
The position of each button on the right side corresponds to the position on the [Copy] screen.
3
Select a feature to display, and select [Save].
z
Select [ ] to display the previous screen or [ ] to display the next screen.
4
Repeat steps 2 and 3 as required.
5
Select [Save].
Preset Buttons
Paper Supply - Button 2 - 5
Select the paper tray displayed in the second to fifth buttons in [Paper Supply] on the
[Copy] screen.
Reduce/Enlarge - Button 3 - 4
Select the magnification ratio displayed in the third and fourth buttons in [Reduce/Enlarge]
on the [Copy] screen.Select the ratio from the Reduce/Enlarge Preset buttons registered.
Front Cover Tray - Button 1 - 3
Set the default value of the tray displayed in [Paper Supply] when an option that printed on
Front Cover is selected for [Front Cover] under [Output Format] > [Covers].
Back Cover Tray - Button 1 - 3
Set the default value of the tray displayed in [Paper Supply] when an option that printed on
Back Cover is selected for [Back Cover] under [Output Format] > [Covers].
Copy Defaults
You can set the default settings of the Copy feature. When the machine is turned on,or the
machine exits the Power Saver mode, or when the <Clear All> button is pressed, the
machine resets to the default values set here. Setting frequently used features and values
as the defaults can avoid extra operations required during the use of the machine.
To Next Page
Loading...
Need help?
General
