HP-GL/2 Emulation
689
Appendix
16
Font Caching
To ensure hi-speed printing, outline fonts of up to a certain size are cached. Outline fonts
are converted into bitmap data temporarily and then printed. To minimize this processing
time, the processed bitmap data is saved in the memory. This process is called font caching.
The saved bitmap data is deleted when you turn the machine off or reset it. For the PCL
emulation mode, data other than that being processed is not saved.
Output Feature
This section describes the machine's output features. The following two output features are
available:
z
Outputting a Pending Print Job
z
Forcible Output in Emulation Mode
Outputting a Pending Print Job
The printing of jobs already received by the machine can be prioritized over other jobs.
z
For information on prioritizing the printing of jobs already received by the machine, refer to "11 Job Status" > "Printing Pending
Jobs" in the User Guide.
Forcible Output in Emulation Mode
Factory Default Settings
In HP-GL or HP-GL/2 emulation mode factory default setting, the document is reduced or
enlarged to print according to the paper size (Auto Layout).
îš„ Document: Auto, Coordinate Origin: 0 degrees, Scaling Mode: Paper Size, Scaling: On
z
Change the factory default setting if required. For more information on changing procedures, refer to "HP-
GL/2 Emulation" (P.688).
îš„ When the extra Hard Disk is installed on the printer
When Auto Layout is enabled, the print data is stored to the hard disk.
To Next Page
Loading...
Need help?
General
