190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page 5-58
5.6.2 Sensors
Configure each connected EIS sensor as shown in Appendix Section C.19. The following steps are required
for this section:
1. Determine all installed EIS sensors that interface to the GI 275 system.
2. Navigate to the System Info → Devices Online page and verify that EIS 1/2 has a green
checkmark.
3. Navigate to EIS → Sensors.
4. Select the Sensor Model configuration shown in Appendix Section C.19 for each sensor.
Figure 5-21 Sensor Menu Example
a. Touch File Location and then select the source.
b. Select the wired GEA port, if applicable, via the Port Select field. If not applicable, there will
be no Port Select field.
c. Touch Model and then select the installed sensor. A silver checkmark will appear if the
configuration is valid. A yellow triangle will appear if the configuration is not valid.
d. Touch Enter.
An example configuration of a TIT sensor is shown in Figure 5-22. The selection sequence is highlighted.
To Next Page
Loading...
Need help?
General
