190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page 3-6
3.1.3 Special Tools Required
The following tools are required for building the wire harness.
Milliohm Meter
A milliohm meter with an accuracy of ±0.1 milliohm (or better) to perform continuity and power/ground
checks.
Crimp Tool
A crimp tool meeting MIL specification M22520/2-01 and a positioner/locator are required to ensure
consistent, reliable crimp contact connections for the rear D-sub connectors. Refer to Table 3-7.
Table 3-7 Recommended Crimp Tools
Non-Garmin part numbers shown are not maintained by Garmin and are subject to change without notice.
Notes:
[1] For configuration module pins, verify the crimp tool is set to crimp 28 AWG wire.
GSB 15 Installation
A crimp tool is required for the GSB 15 installation. The recommended crimp tool is Molex Hand Crimp
Tool (P/N 638190000). For other options, refer to GSB 15 Installation Manual (P/N 190-00303-A3).
Manufacturer
Hand
Crimping
Tool
22-28 AWG 22-24 AWG
Positioner [1]
Insertion/
Extraction Tool
Positioner
Insertion/
Extraction Tool
Military P/N M22520/2-01 M22520/2-09 M81969/14-01 M22520/2-08 M81969/1-02
ITT Cannon 995-0001-584 995-0001-739 N/A N/A N/A
Positronic 9507 N/A N/A 9502-5 M81969/1-02
AMP 601966-1 601966-6 91067-1 601966-5 91067-2
Daniels AFM8 K42 N/A K13-1 M81969/1-02
Astro 615717 615725 N/A 615724 M81969/1-02
To Next Page
Loading...
Need help?
General
