190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page 5-85
5.9.9 Analog Inputs
The Analog In page shows the voltage of each Analog Input.
5.9.10 GDL69
The GDL 69 page shows information for a configured GDL 69/69A SXM.
5.9.11 ARINC 429
The ARINC 429 page shows the status of each ARINC 429 port.
5.9.12 RS-232
The RS-232 page shows the status (Active/Inactive) of each RS-232 connection. Yellow indicates that the
port is not actively receiving or transmitting data.
5.9.13 RS-485
The RS-485 page shows the status (Active/Inactive) of the RS-485 connection. Yellow indicates that the
port is not actively receiving or transmitting data.
5.9.14 GFC 500
The GFC 500 page shows the Autopilot Disconnect Input status for the GFC 500 roll, pitch, and yaw
servos, as well as the manual pitch trim switch status.
5.9.15 Clear Config
CAUTION
Touching the Clear Config button will erase all configuration settings.
5.9.16 Factory Reset
CAUTION
Touching the Factory Reset button will restore the unit to its factory defaults, including
reseting calibration results. It is not recommended to select this option when
troubleshooting.
To Next Page
Loading...
Need help?
General
