190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page C-8
C.5 VHF Navigation Receiver
The VHF navigation receivers listed in Table C-6 are compatible with the GI 275. For a list of analog navigation receivers compatible with the GI 275, refer to
Appendix Section C.6.
Table C-6 Compatible VHF Navigation Receiver
Mfr Model Data Format Interfacing Equipment Configuration Information Notes
Garmin
Other GI 275 HSDB
Crossfills data from a different
GI 275 interfaced to a NAV
source.
GNC 255 RS-232
Serial Port page IO MODE: NMEA
Can be NAV 1, NAV 2, or both.
CDI Indicator page
When GI 275 NAV CDI is desired to be driven by
a “standard CDI” connected to the GNC 255, set
TYPE: RESOLVER.
When GI 275 NAV CDI is desired to be set via the
GI 275 interface, set TYPE: SERIAL.
When GI 275 NAV CDI is desired to be set via the
GI 275 interface and/or the GNC 255 display, set
TYPE: NONE.
GNS 430W/430AW
GNS 530W/530AW
ARINC 429
VOR/LOC/GS
ARINC 429 Config
page
SPEED: TX: Low
SDI: VOR/ILS 1 (for NAV 1)
VOR/ILS 2 (for NAV 2)
Can be NAV 1, NAV 2, or both.
GNS 480 (CNX80) ARINC 429
ARINC 429 Setup
page
CH OUT 2: SEL: VOR/ILS
SPEED: Low
SDI: Sys 1 (for NAV 1)
Sys 2 (for NAV 2)
Can be NAV 1, NAV 2, or both.
GTN 650
GTN 750
HSDB
HSDB Port
Utilization page
Ethernet Port ( ): Connected
Software v6.70 or later required.
Can be NAV 1, NAV 2, or both.
GTN 650Xi
GTN 750Xi
HSDB
HSDB Port
Utilization page
Ethernet Port ( ): Connected
Software v20.10 or later
required.
Can be NAV 1, NAV 2, or both.
To Next Page
Loading...
Need help?
General
