190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page G-5
G.2.1.1.2 Aircraft Limited to VFR Operation
This zoning section is applicable to those aircraft models that are limited to VFR operation only in
Appendix D. For zoning of models that are not limited to VFR operation only, refer to Appendix Section
G.2.1.1.1.
NOTE
The aircraft must have a position light in the wing tip area as a prerequisite for this STC.
If there is no position light on the wing, then no Zone 3 exists and the GTP 59 cannot be installed on this
particular aircraft. For those aircraft identified as VFR in Appendix D, the following criteria is used to
determine the Zone 3 area:
• Zone 1A/1B finishes as shown in Figure G-3 or 0.5 meters inboard from the inboard edge of the
position light, whichever is the greater distance from the outboard edge of the wing tip, as shown
in Figure G-4
• Zone 2A/2B extends a total of 2.1 meters inboard of Zone 1A/1B
• Zone 3 extends inboard of Zone 2A/2B from the wing tip and stops at another Zone 1A/1B or
2A/2B determined from other areas of Appendix Section G.2.2
To Next Page
Loading...
Need help?
General
