Operation
50940411/G0219 74 Printed in U.S.A.
Parking Brake
The parking is automatically applied whenever
either of the safety bars/arm rests are in the raised
position (B, Fig. 51), the operator leaves the seat or
the cab front door is opened.
Before starting the engine, sit in the operator’s seat
and lower the safety bars/arm rests. On machines
equipped with a cab, close the door.
NOTE:
Raising the safety bars/arm rests, leaving
the operator’s seat or opening the cab door also
locks out work hydraulic functions, with the
exception of standard auxiliary hydraulics
continuous flow.
IMPORTANT: The engine cannot be started if the
safety bars/arm rests are in the raised position, the
cab door is open or the operator is not in the seat.
Disengage Parking Brake
1. Sit in the operator’s seat and fasten the seat belt.
2. Close the cab door, if equipped.
3. Lower the safety bars/arm rests.
4. Start the engine.
NOTE:
If the engine does not start due to failure to
perform any of steps 1-3, the error code “0” is
displayed on the multi-function display.
5. Press and hold the top of the parking brake
switch (C, Fig. 52) for several seconds until the
indicator lights in the switch and on the multi-
function display go out.
Fig. 51 – Safety Bars/Arm Rests in Raised
Position
B
Fig. 52 – Parking Brake Indicators/Disengage
Switch
C
To Next Page
Loading...
Need help?
General
