216 Vehicle care
Bulb replacement
Contact a trained service technician
if unsure about the bulb replacement
process.
When replacing bulbs:
• Turn the ignition off and remove
the key.
• Turn off related switches.
• Fit bulbs of the specied
wattage only.
• Do not touch bulbs or reectors
with bare hands.
• Clean stained bulbs with
methylated spirits.
• For passenger side bulb
replacement, remove the washer
neck by rotating anticlockwise
and pulling out. To replace the
washer neck, rotate clockwise
until it clicks into place.
Bulbs to be changed by
a Holden Dealer
• Side turn signal lamps
• Centre High Mounted Stoplamp
(CHMSL)
• Courtesy lamps
• Fog lamps
Caution
Condensation may temporarily
appear on the inside of exterior
lamp lenses after rain or washing
the vehicle. Condensation occurs
when there is a temperature
difference between the inside and
outside of the lamp allowing a
îš¿ne mist on the inside surface of
the lamp lens. This condensation
will disappear when the vehicle is
in a dry environment or the lamp
is on. If water does collect in the
lamp contact a Holden Dealer.
Headlamps
Low and high beam
1. Remove the protective cover.
2. Disconnect the electrical
connector.
To Next Page
Loading...
Need help?
General
