Honeywell FlexLine SmartServo 954 User Manual

COMMISSIONING
102 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
☛ If [Local] [Monitor Mode] is to be set, skip to next bullet ().
☛ From the [Monitor Mode], select [Remote].
☛ Select [Remote Threshold Source], set desired value.
 If the [Monitor Mode] is set to [Local], the scanned PV or SV
value is compared against the value set in the [Threshold]
entity. The behavior is modified by the [Threshold Mode]
and the [Hysteresis] entities. The [Threshold Mode] entity
can be set to either <Treat as HA> or <Treat as LA>.
If the [Threshold Mode] entity is set to <Treat as HA>, the
relay is activated if the scanned PV or SV is greater than or
equal to the [Threshold] entity value, and the relay is
deactivated if the scanned PV or SV is less than the
[Threshold] entity value minus the [Hysteresis] entity value.
If the [Threshold Mode] entity is set to <Treat as LA>, the
relay is activated if the scanned PV or SV is greater than or
equal to the [Threshold] entity value, and the relay is
deactivated if the scanned PV or SV is less than the
[Threshold] entity value plus the [Hysteresis] entity value.
☛ From the [Monitor Mode], select [Local].
☛ Select [Threshold Mode], and choose either <Treat as HA> or
<Treat as LA>.
☛ Select [Hysteresis], set desired value.
7.3.6.4.3 Status Behavior
The Status Behavior entity determines what happens to the relay if the
health of the scanned PV or SV differs from Good. The [Status
Behavior] should be set to one of the following options: <BAD>, <BAD-
UNCERTAIN>, or <Not Used>.
If the [Status Behavior] is set to <BAD>, and the scanned PV or SV
health is Bad, the respective relay will be activated.
If the [Status Behavior] is set to <BAD-UNCERTAIN>, and the scanned
PV or SV health is Bad or Uncertain, the respective relay will be
activated.

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English