Honeywell FlexLine SmartServo 954 User Manual

SYSTEM ARCHITECTURE
Part No.: 4417340 Revision 1 Service Manual 23
954 SmartServo FlexLine
The following tables provides information about the status code and the
specific reason why the status is good, uncertain, or bad. This
information is presented as an information number coupled with a
textual description of this specific situation.
Good Uncertain Bad
actual
manual
last
valid
stored
instrument
environment
un-init
killed
no data
under range
over range
hw fail
sw fail
cal fail
001 056 077 104 632 328 207 782 065 478 199 389 011 072
........................................................
 Each board implements “health” as generic information
based on the function (s) health(s).
 Each function implements “health” as generic information.
 Each sensor and digital I/O function implements an entity
called “Primary Value”, which in addition to the actual
measured value also contains a “health” status.
4.3.1.2 Commissioned En tity
The “Commissioned” entity informs the end user if the most important
commissioning entities of the concerned FlexConn module and its
implemented functions are set correctly.
 True = the most important entities are set correctly
 False = the most important entities are not set correctly

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English