118 User Guide Integrated Lights-Out
Action Key Sequence Comments
POWER OFF CTRL P 0 CTRL P is the prefix for the Power
commands. The 0 indicates an OFF
selection.
ACPI PRESS CTRL P 6 CTRL P is the prefix for the Power
commands. The 6 indicates an ACPI
power press. The ACPI power press is
equivalent to holding the power button for
approximately 6 seconds.
SYSTEM
REBOOT
CTRL P ! CTRL P is the prefix for the Power
commands. The ! indicates an immediate
emergency reboot.
UID ON CTRL U 1
CTRL U is the prefix for the UID
commands. The 1 indicates an ON
UID OFF CTRL U 0 CTRL U is the prefix for the UID
commands. The 0 indicates an OFF
selection.
Key sequences operate during a telnet Remote Console session or Virtual Serial
Port session. The keys do not work before authentication. The power control
requests are correctly ignored when you do not have the correct power control
privileges.
Telnet Security
Telnet is an unsecured network protocol. To reduce any security risks:
•
•
Use SSH instead of telnet. SSH is essentially secure or encrypted telnet. CLI
is supported through telnet as well as SSH.
Use a segregated management network. Preventing unauthorized access to
the network segment prevents unauthorized activity.
Supported Key Sequences
iLO supports the VT100+ protocol. The following tables define the supported
key sequences.
To Next Page
Loading...
Need help?
General