To Next Page

To Previous Page

Using iLO 123

Key Sequence

END_KEY \e[4~

PG_UP \e[5~

PG_DOWN \e[6~

•

Secure Shell

SSH is a telnet-like program for logging into and for executing commands on a

remote machine, which includes security with authentication, encryption, and

data integrity features. iLO can support simultaneous access from two SSH

clients. After SSH is connected and authenticated, the command line interface is

available.

iLO supports:

SSH protocol version 2

PuTTY 0.54, which is a free version of telnet and SSH protocol available for

download on the Internet. When using PuTTY, versions before 0.54 may

display 2 line feeds instead on a single line feed, when the ENTER key is

pressed. To avoid this issue and for best results, HP recommends using

version 0.54 or later.

OpenSSH, which is a free version of the SSH protocol available for

download on the Internet.

When upgrading the firmware to version 1.60, there will be a one-time 25 minute

delay before SSH functionality is available. During this time, iLO generates the

1024 bit RSA and DSA keys. These keys are saved by iLO for future use. If iLO

is reset to factory defaults, the RSA and DSA keys are erased and are regenerated

on the next boot.

Using Secure Shell

Using SSH

To access iLO using SSH:

HP Integrated Lights-Out User Manual

Questions and Answers: