HP Integrated Lights-Out User Manual

Using iLO 125
Feature
Language English
Client/User authentication method Password
Authentication timeout 2 minutes
Authentication attempts 3
Default SSH port 22
iLO Shared Network Port
The iLO Shared Network Port enables you to choose either the system NIC or
the dedicated iLO NIC for server management. Both regular network traffic and
network traffic intended for iLO pass through the system NIC when this feature
is selected. The iLO Shared Network Port is only available on a limited number
of ProLiant servers, as shown in the “iLO Shared Network Port Requirements
(on page 125
)” section.
Not all iLO management features are available when using the iLO Shared
Network Port. Refer to the “iLO Shared Management Port Features and
Restrictions (on page 126
)” section for a list of supported and unsupported iLO
management features.
iLO Shared Network Port Requirements
The iLO Shared Network Port feature is only available on servers with hardware
that supports this feature. In addition to the hardware, both the NIC and iLO
firmware must support the feature.
ProLiant Server Minimum iLO firmware version
DL360 G4 1.60
DL380 G4 1.60
ML370 G4 1.60
When using the iLO Shared Network Port, flashing the iLO firmware through the
XML interface will take approximately 7 minutes to complete.

HP Integrated Lights-Out Specifications

General

Brand	HP
Model	Integrated Lights-Out
Category	Software
Language	English