Procedure
Step 1 Turn o the power switch of the VCN510, disconnect the power supply of the
VCN510, remove the cables from the VCN510, label the cables, and record the
original connection positions of the cables.
After removing cables, wrap exposed terminals with insulation tape and do not
block cable labels. If cable labels are blocked, cables may be connected incorrectly
later.
Step 2 Remove the faulty VCN510 from the cabinet.
Step 3 Carry the device to be cabinet. Ensure that the mounting ears at both sides of the
device are tightly attached to the mounting bar in front of the cabinet. Use one
hand to hold the device. Use the other hand to thread M6 screws through the
slotted hole on the mounting ear. Use a Phillips screwdriver to
x the M6 screws
on the mounting ears. Each mounting ear uses two M6 screws.
Figure 6-16 Installing the device
Step 4 Reconnect the cables to the new VCN510.
Step 5 Turn on the power switch of the VCN510.
Step 6 Commissioning the VCN510. If the video recording function works properly after
commissioning, the VCN510 is functional.
----End
6.4.3.7 Replacing a T/H Sensor (33010516)
Prerequisites
● A T/H sensor needs to be replaced.
● A spare T/H sensor of the same model is available and functional.
FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S) 6 O&M
Issue 02 (2021-06-30) Copyright © Huawei Technologies Co., Ltd. 192
To Next Page
Loading...
Need help?
General