Figure 4-33 Adjusting the camera
● By default, the camera is horizontally installed, and the surveillance video is
displayed horizontally. During the installation, adjust the surveillance angle to
avoid video image rotation after the installation.
● When adjusting the surveillance angle, pay attention to the position of the
illuminator to prevent the illuminator from being blocked.
The camera features a three-axis design. The camera can be adjusted by –175° to +180°
horizontally, and the lens can rotate –175° to +180° and be adjusted by 0° to 65° vertically.
Step 6 Align the transparent cover with the screw holes on the base, close the
transparent cover, and use a Phillips screwdriver to tighten the screws to 0.8 N·m.
Figure 4-34 Installing the transparent cover
----End
4.2.6.8 (Optional) Installing a LAN Switch
Procedure
Step 1 Locate the LAN switch installation position in the cabinet, and install guide rails
and oating nuts.
Step 2 Install the mounting ears delivered with the LAN switch and secure the LAN
switch to the rack rails at the front of the cabinet.
FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S) 4 Installation Guide
Issue 02 (2021-06-30) Copyright © Huawei Technologies Co., Ltd. 82
To Next Page
Loading...
Need help?
General