Hydac CS1000 series User Manual

Performing maintenance
Performing maintenance
The sensor is maintenance-free. Check the calibration cyclically, as
described in the "Calibrating the sensor" chapter.
Clean the display / control panel regularly, as described in the "Cleaning the
display / user interface" chapter.
Calibrating the sensor
We recommend recalibrating the sensor every 2-3 years unless otherwise
specified at a HYDAC-certified Customer Service or Service Center.
Addresses can be found on page 120 or on www.hydac.com.
Cleaning the display / user interface
Clean the display / control panel with a clean, moist cloth. Do not use any
chemical cleaning agents as these may damage the film attached to the
surface of the unit.
Decommissioning the sensor
To decommission, proceed as follows:
1.
Disconnect and remove the electric connection to the sensor
2.
Close any shut-off devices in the feed and return lines of the
sensor.
2.
Depressurize the unit.
3.
Remove the hydraulic connection lines to the sensor.
4.
Remove the sensor.
Disposing of the sensor
Dispose of the packaging material in an environmentally friendly manner.
After removing the sensor and separating its various materials, dispose of it
in an environmentally friendly manner.
ContaminationSensor CS1000
en(us)
Page 116 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25

Hydac CS1000 series Specifications

General

Brand	Hydac
Model	CS1000 series
Category	Accessories
Language	English