Hydac CS1000 series User Manual

Annex
- EGDeclaration of conformity
Request an EG declaration of conformity from HYDAC, if necessary. The
contact data can be found on Page 8.
Glossary
Single
measurement
A single measurement means the analysis of the
contamination in a sample, which flows through the
sensor during the configured measurement period. The
result of a single measurement is the measured value.
Measuring point
This is the name for the point in the hydraulic,
lubrication or fluid system where a measurement is
carried out.
Test volume
Sample quantity which is analyzed for determining a
measured value.
Measured value
The contamination codes determined by a single
measurement, shown as a three-digit ISO code or NAS
codes or SAE codes of the individual particle size
channels.
Measurement
duration
Once the measurement duration has elapsed, the
measured value is updated which is shown on the
display and presented at the interface.
The measurement duration is configurable using the
parameter.
Measurement
Once a CS device has been connected to the electrical
power and its boot process has completed, a single
measurement will start, after which the next single
measurement will immediately follow, and so on, until
the CS device is disconnected from the power (MODE
M1, M2, M4) or until the programmed target purity
(MODE M3) has been reached.
This series of single measurements is referred to as a
measurement for convenience reasons.
ContaminationSensor CS1000
en(us)
Page 129 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25

Hydac CS1000 series Specifications

General

Brand	Hydac
Model	CS1000 series
Category	Accessories
Language	English