The select button and navigation buttons help you to navigate and select menu
and boot options, and start a service panel test.
The select button is located on the front panel of the SAN Volume Controller, near
the navigation buttons.
Front panel display
The front panel display shows service, configuration, and navigation information.
Information on the front panel display is available in several languages. The
display can show both alphanumeric information and graphical information
(progress bars).
The front panel displays configuration and service information about the SAN
Volume Controller and the SAN Volume Controller cluster, including the following
items:
v Boot progress indicator
v Boot failed
v Charging
v Hardware boot
v Node rescue request
v Power failure
v Powering off
v Recovering
v Restarting
v Shutting down
v Error codes
Node identification label
The node identification label on the front panel displays a six-digit node
identification number.
The node identification label is the same as the six-digit number that is used in the
svctask addnode command. It is readable by system software and is used by
configuration and service software as a node identifier. The node identifier can also
be displayed on the front panel display when node is selected from the menu.
If the service controller assembly front panel is replaced, the configuration and
service software displays the number that is printed on the front of the
replacement panel. Future error reports contain the new number. No cluster
reconfiguration is necessary when the front panel is replaced.
SAN Volume Controller 2145-4F2 rear panel indicators
The following figure shows the rear panel indicators on the SAN Volume
Controller 2145-4F2 back panel assembly.
Appendix B. SAN Volume Controller 2145-4F2 105
To Next Page
Loading...
Need help?
General
