4. Place the other end of the signal cable into any vacant position on the top row
of serial connectors
4
on the 2145 UPS.
Attention: Do not plug any signal cables into the bottom row of signal cable
connectors or the 2145 UPS malfunctions.
The
SAN Volume Controller 2145-4F2 power is now connected to the 2145 UPS.
Connecting the SAN Volume Controller 2145-4F2 to the SAN
and to the Ethernet network
Before you connect the SAN Volume Controller 2145-4F2 to the SAN, you must
connect the Ethernet and fibre-channel cables.
Before you begin this task, refer to the user’s cable connection table to find out
where to connect the Ethernet and fibre-channel cables.
1. Connect the Ethernet cable to Ethernet port 1
5
in Figure 99.
Attention: You must use only Ethernet port 1 on the SAN Volume Controller.
The software is configured only for Ethernet port 1.
2. Connect the other end of the Ethernet cable to the proper connector on the
Ethernet hub or switch.
1
Fibre-channel port 1
2
Fibre-channel port 2
3
Fibre-channel port 3
4
Fibre-channel port 4
5
Ethernet port 1
Attention: When routing the fibre-channel cables, do not tighten the cable
straps or bend the cables to a radius smaller than 76 mm (3 in.).
3. Connect the fibre-channel cables to the fibre-channel ports as required by the
user’s configuration.
4. Connect the other ends of the fibre-channel cables to the proper connectors of
the fibre-channel switches.
Complete steps 1 through 4 for each node that you need to connect to the SAN
and to the Ethernet network.
5
21
3
4
svc00360
Figure 99. Connectors at the back of the SAN Volume Controller 2145-4F2
136 IBM System Storage SAN Volume Controller: Hardware Installation Guide
To Next Page
Loading...
Need help?
General
