To Next Page

To Previous Page

3. If you have not already connected the internal battery connector, remove the

2145 UPS-1U front panel.

4. Remove the protective label from the internal battery connector.

5. Connect the internal battery connector. Each end of the keyed connector has

two wires: one red (+) and one black (−). Join the black wires and the red wires

together.

Note: A small amount of arcing might occur when connecting the batteries.

This is normal and does not damage the unit or present any safety

concerns.

svc00063

Figure 19. Removing the 2145 UPS-1U front panel

svc00062

Figure 20. The 2145 UPS-1U internal battery connector with protective tape

Chapter 6. Installing the SAN Volume Controller 2145-8G4 hardware 45

Questions and Answers:

Need help?

Do you have a question about the IBM 2145UPS-1U and is the answer not in the manual?

IBM 2145UPS-1U Specifications

General