You need the following items for each node:
1
SAN Volume Controller node
2
SAN Volume Controller support rails (2)
3
UPS
4
UPS support rails (2)
5
Power and signal cable
6
2145 UPS-1U cable retention bracket
7
SAN Volume Controller 2145-8G4 cable retention bracket (the actual
design might differ)
8
Optionally, one or more redundant ac power switches, two side plates
per switch, and power cables.
Note:
a. You must install at least two SAN Volume Controller nodes and each
node requires a UPS.
b. You must ensure that you have the appropriate power cables to
connect to the site power distribution point. See “Power cables for
the 2145 UPS-1U” on page 28.
c. Optionally, install two redundant ac power switches to power the
nodes in an I/O group through two 2145 UPS-1Us.
3.
If you are installing UPSs, read through the safety and environmental notices.
4. If you are installing the master console, be sure to read all of the safety checks
that are detailed in the IBM System Storage Master Console for SAN File System
and SAN Volume Controller: Installation and User’s Guide. Refer to the IBM System
Storage SAN Volume Controller: Planning Guide, which provides the configuration
data table, and to http://www.ibm.com/storage/support/2145 where you can
22khqt
1
3
2
8
4
7
6
5
Figure 10. Parts provided for SAN Volume Controller hardware installation in a rack
36 IBM System Storage SAN Volume Controller: Hardware Installation Guide
|
|
|
|
To Next Page
Loading...
Need help?
General
