Chapter 1 — About the Printer
PM23c, PM43, and PM43c Mid-Range Printer User Manual 19
Set the Command Language from the Printer Web Page
To set the command language from the printer web page, you need to
turn on the printer and connect to your Ethernet or Wi-Fi network.
1 Make sure that the printer has media and ribbon (if necessary)
installed.
2 On your PC, open a browser.
3 In the Location or Address bar, type the printer IP address and
press Enter. The printer web page appears.
4 Click Login. The Login page appears.
5 Type your Username and Password and click Login. The default
username is itadmin and the default password is pass.
6 Click the Configure tab.
7 Click System Settings > General.
8 Select a different printer command language from the Command
Language list, and then click Save.
9 Click the Services tab.
10 Click Reboot Printer, and then click Reboot. The printer restarts
in the command language you selected.
Set the Command Language from the Main Menu
If you have a full touch printer, you can use this procedure to change
the printer command language from the Main Menu.
1 From the Ready screen, press the Main Menu button.
2 From the Main Menu, press Settings > System Settings > General.
3 Scroll down until you reach Command Language.
4 Use the horizontal scroll bar to select the command language you
want to use and then save your change.
5 Turn the printer off and then on. The printer starts up in the
command language you selected.
To Next Page
Loading...
Need help?
General