Chapter 3 — Connect the Printer
50 PM23c, PM43, and PM43c Mid-Range Printer User Manual
About Wireless Communications
The printer supports wireless communications when the optional
Wi-Fi/Bluetooth module is installed.
You can configure wireless communications:
• from the printer web page.
• from the printer Main menu if your printer has full touch display
front panel.
By default, the printer supports DHCP networks.
Configure Wireless Communications from the Web
Page
Use this procedure to configure wireless communications from the
printer web page.
1 Open a web browser on your PC.
IPv4 and IPv6 Ethernet Settings
Setting Default
(IPv4) IP Assignment Method DHCP
(IPv4) IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Default Router 0.0.0.0
DHCP Response Broadcast
(IPv6) IP Assignment Method Automatic
(IPv6) IP Address Automatic
Note: If you are not using a DHCP network, you need to configure
Wi-Fi settings by using Intermec PrintSet through a USB connection
to the printer, by sending commands through a serial connection, or
by using the wizards and settings menus on a full touch printer.
Note: To configure the printer from the web page, the printer must be
turned on and connected to your Wi-Fi or Ethernet network.
To Next Page
Loading...
Need help?
General