Intermec PM23c User Manual

Appendix B — Default Settings
132 PM23c, PM43, and PM43c Mid-Range Printer User Manual
Wireless 802.11 Security Settings
This section describes the 802.11 security settings. To view these
settings:
• From the printer Main Menu, select Settings > Communications
> Wireless 802.11 > Security.
• From the printer web page, click the Configure tab >
Communications > Wireless 802.11.
Default Router Sets the IP address of a router that is
used when a device sends a packet to
another subnet or to an unknown
destination.
0.0.0.0
DHCP Response Sets if the printer receives DHCP
responses by broadcast or unicast.
Broadcast
(IPv6) IP
Assignment
Method
Sets how the printer obtains an IP
address (for IPv6 networks).
Automatic
(IPv6) IP Address Sets the unique network-level address
that is assigned to each device in an
IPv6 network.
Automatic
Wireless 802.11 Network Settings (Continued)
Setting Description Default
Wireless 802.11 Security Settings
Setting Description Default
Security Type Selects the protocol the radio uses to
verify its identity and makes sure that
it is authorized to communicate on
the wireless network.
None
Association Selects the security method that the
radio uses to get access to the wireless
network.
Open/WEP
Pre-Shared Key Defines the passphrase that allows
the radio to authenticate over the
wireless network (for both WPA and
WPA2 security). Range is 8 to 64
characters.
None

Intermec PM23c Specifications

General

Brand	Intermec
Model	PM23c
Category	Printer
Language	English