SWEep Subsystem
Copyright © ITECH Electronic Co., Ltd. 99
Query syntax
SWEep:FREQ:STOP? [A|B|C][MAXimum|MINimum|DEFault]
Returns
<NR2>
Example
SWEep:FREQ:STOP 1 //Set the stop frequency of sweep to 1Hz.
SWEep:FREQ:STOP? //Query the presently set stop frequency.
SWEep:FREQ:STOP? MAX //Query the maximum value of the stop frequency.
SWEep:FREQ:STEP <NRf+>[,<NRf+>,<NRf+>]
This command is used to set and query step frequency of sweep.
<NRf+>: step frequency setting value, or step frequency MINimum or MAXimum
or DEFault setting.
Note:
In single-phase (including AC, ACDC, DC, DCAC), there is only one parameter; in
three-phase, three parameters must be taken.
Syntax
SWEep:FREQ:STEP <NRf+>[,<NRf+>,<NRf+>]
Argument
<NRf+>[,<NRf+>,<NRf+>]
*RST
0
Query syntax
SWEep:FREQ:STEP? [A|B|C][MAXimum|MINimum|DEFault]
Returns
< NR2>
Example
SWEep:FREQ:STEP 1 //Set the step frequency of sweep to 1Hz.
SWEep:FREQ:STEP? // Query the presently set step frequency.
SWEep:FREQ:STEP? MAX //Query the maximum value of step frequency.
SWEep:TIMe:STEP <NRf+>[,<NRf+>,<NRf+>]
This command is used to set and query the single-step execution time of sweep.
It is valid when the mode is TIMe.
<NRf+>: step time setting value, or step time MINimum or MAXimum or DEFault
To Next Page
Loading...
Need help?
General
