SOURce Commands
Copyright © ITECH Electronic Co., Ltd. 39
Query syntax:
VOLTage:SLOPe[:IMMediate]:DC? [MAXimum|MINimum| DEFault]
Example
VOLT:SLOP:DC 300.0
VOLT:SLOP:DC?
VOLT:SLOP:DC? MAX
[SOURce:]PVOLtage:SLOPe[:IMMediate]:DC
<phase>,<NRf+>
Set and query the DC voltage slope in normal mode.
Phase: phase identification.
NRf+: DC voltage slope setting value.
Syntax:
[SOURce]PVOLtage
:SLOPe[:IMMedia
te]:DC <phase>,<NR
f+>
Query syntax:
PVOLtage:SLOPe[
:IMMediate]:DC?
<phase>,[MAXi
mum|MINimum| DEF
ault]
*RST:
10V/ms
Example
PVOLT:SLOP:DC C,300.0
PVOLT:SLOP:DC? C
PVOLT:SLOP:DC? C,MAX
[SOURce:]FREQuency[:IMMediate]
<NRf+>[,NRf+][,NRf+]
This command is used to set and query the frequency value in normal mode.
<NRf+>: frequency setting value.
Note: in multi-channel, this command must carry three parameters to set at the
same time, or use PFREquency to set a separate frequency.
Syntax:
FREQuency[:IMMediate] <NRf+>[,NRf+][,NRf+]
Arguments:
MAXimum|MINimum|DEFault
To Next Page
Loading...
Need help?
General
