To Next Page

To Previous Page

ARB Subsystem

Syntax

[ARB:]LIST:CLEar

Example

LIST:CLE

[ARB:]LIST:STEP <NR1>,<string>

This command is used to configure and query the list step parameters.

<NR1>: step index

<string>: the parameters are separated by commas, and the specific order is as

follows:

⚫ Three phase

A_Vac: AC voltage of A Phase

B_Vac: AC voltage of B Phase

C_Vac: AC voltage of C Phase

A_Vac_slew: AC voltage slope of phase A

B_Vac_slew: AC voltage slope of phase B

C_Vac_slew: AC voltage slope of phase C

A_Vdc: DC voltage of A Phase

B_Vdc : DC voltage of B Phase

C_Vdc : DC voltage of C Phase

A_Vdc_slew: DC voltage slope of phase A

B_Vdc_slew: DC voltage slope of phase B

C_Vdc_slew: DC voltage slope of phase C

Phase mode: CONTinues|PHASe

A_start: starting angle of phase A

ba_diff: phase difference of BA

ba_diff_slew: Phase differenct slew rate of BA

ca_diff : phase difference of CA

ca_diff_slew : Phase differenct slew rate of CA

Frequency: Frequency

Frequency_slew: frequency slope

A_wave: waveform type of phase A

B_wave: waveform type of phase B

C_wave: waveform type of phase C

Step Jump para1: step jump mode, TIME|TRIGger|PHASe

Step Jump para2: if the para1 is set to TIME, this parameter is time value. If the

para1 is set to TRIGger, this parameter is IMMe or PHASe. And if para1 is set to

PHASe, this parameter is angle value.

Step Jump para3: if para1 is set to TRIGger and para2 is set to PHASe, this

ITech IT7900 Series Programming Guide

Other manuals for ITech IT7900 Series