ITech IT7900 Series Programming Guide

WAVEform Subsystem
Copyright © ITECH Electronic Co., Ltd. 123
Chapter18 WAVEform Subsystem
WAVEform[:IMMediate] <WAVEform>,[WAVEform],[WAVEform]
This command is used to set and query the waveform in Normal mode. For the
waveform with parameters, the parameters are set to default values.
Syntax
WAVEform[:IMMediate] <WAVEform>,[WAVEform],[WAVEform]
Arguments
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
*RST
Sine
Query syntax
WAVEform?
Returns
<string>
Example
WAVE "Sine" // Set the waveform to Sine.
WAVE "Sine","Saw","Square" // Set three channel waveforms separately, valid
under three-phase unbalanced or multi-channel.
WAVE?
PWAVeform[:IMMediate] <phase/chan>,<WAVEform>
This command is used to set and query the waveform of a phase/channel in
Normal mode. For waveforms with parameters, the parameters are set to default
values.
Syntax
PWAVeform[:IMMediate] <phase/chan>,<WAVEform>
Arguments
<A|B|C|CH1|CH2|CH3>,
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English