ITech IT7900 Series Programming Guide

STATus Commands
Copyright © ITECH Electronic Co., Ltd. 121
Arguments
0-0x7fffffff
Default value
0|OFF
Example
STATus:OPERation:ENABle 128
Query syntax
STATus:OPERation:ENABle?
Returns
<NR1>
STATus:OPERation:NTRansition<NR1>
Sets the value of the NTR (Negative-Transition) registers. These registers serve
as a polarity filter between the Operation Condition and Operation Event registers.
When a bit in the NTR register is set to 1, then a 1-to-0 transition of the
corresponding bit in the Operation Condition register causes that bit in the
Operation Event register to be set. STATus:PRESet sets all bits in the PTR
registers and clears all bits in the NTR registers.
• If the same bits in both NTR and PTR registers are set to 1, then any transition
of that bit at the Operation Condition register sets the corresponding bit in the
Operation Event register.
• If the same bits in both NTR and PTR registers are set to 0, then no transition of
that bit at the Operation Condition register can set the corresponding bit in the
Operation Event register.
• The value returned is the binary-weighted sum of all enabled bits in the register.
Syntax
STATus:OPERation:NTRansition <NR1>
Arguments
0-0x7fffffff
Default value
0
Example
STATus:OPERation:NTRansition 128
Query syntax
STATus:OPERation:NTRansition?

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English