ITech IT7900 Series Programming Guide

SCOPe Subsystem
Copyright © ITECH Electronic Co., Ltd. 111
Chapter16 SCOPe Subsystem
SCOPe:AUTO
This is an automatic setting command of the oscilloscope.
Syntax
SCOPe:AUTO
Example
SCOPe:AUTO
SCOPe:RUN
This is an operation command of the oscilloscope.
Syntax
SCOPe:RUN
Example
SCOPe:RUN
SCOPe:SINGle
This command is used to capture single-shot oscilloscope data.
Syntax
SCOPe:SINGle
Example
SCOPe:SINGle
SCOPe:STOP
This is a stop command of the oscilloscope.
Syntax
SCOPe:STOP
Example
SCOPe:STOP
SCOPe:TIMebase:SCALe <NRf>
This command is used to set and query the time scale of the oscilloscope, unit: s.
<0.001-1.0>

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English