ITech IT7900 Series Programming Guide

FETCh & MEASure Commands
Copyright © ITECH Electronic Co., Ltd. 61
FETCh[:SCALar]:CURRent:AMPlitude:MAXimum?
MEASure[:SCALar]:CURRent:AMPlitude:MAXimum?
This command is used to read the peak value of single-phase current.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent:AMPlitude:MAXimum? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC:CURR:AMP:MAX?
FETCh[:SCALar]:CURRent:CFACtor?
MEASure [:SCALar]:CURRent:CFACtor?
This command is used to read the current crest factor values of A, B, C
three-phase.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent:CFACtor? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC:CURR:CFAC?

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English