ITech IT7900 Series Programming Guide

FETCh & MEASure Commands
Copyright © ITECH Electronic Co., Ltd. 66
Returns:
<NRf> …
Example:
FETC:VOLT:AMP:MAX:POS?
FETCh[:SCALar]:VOLTage:AMPlitude:MAXimum:NEGative?
MEASure[:SCALar]:VOLTage:AMPlitude:MAXimum:NEGative?
This command is used to read the negative peak value of single-phase voltage.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:VOLTage:AMPlitude:MAXimum:NEGative?
[A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf> …
Example:
FETC:VOLT:AMP:MAX:NEG?
FETCh[:SCALar]?
MEASure[:SCALar]?
This command is used to get all METER data of single phase.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf> …

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English