SOURce Commands
Copyright © ITECH Electronic Co., Ltd. 30
Returns:
MAXimum|MINimum|DEFault
Example
CURR:PROT:DEL 0.5
CURR:PROT:DEL 10,1
[SOURce:]CURRent:PROTection:DELay?
[CH1|CH2|CH3],[MAXimum|MINimum|DEFault]
Query the RMS current protection delay time.
Note: both parameters of this query command are optional.
Syntax:
CURRent:PROTection:DELay? [CH1|CH2|CH3],[MAXimum|MINimum|DEFault]
Arguments:
MAXimum|MINimum|DEFault
Returns:
MAXimum|MINimum|DEFault
Example
CURR:PROT:DEL?
CURR:PROT:DEL? MAX|MIN
CURR:PROT:DEL? 1, MAX|MIN
[SOURce:]CURRent:PROTection:MODE <CPD> [,CH1|CH2|CH3]
This command sets and queries the mode of RMS current protection.
SHUTup: If the measured RMS current value is greater than or equal to the set
value and greater than the protection delay time, protection is generated and the
output of the machine is turned off.
LIMit: In the same way, when the protection is generated, the machine will still
output with the Limit value.
Syntax:
CURRent:PROTection:MODE <CPD> [,CH1|CH2|CH3]
Arguments:
LIMit|SHUTup
Query syntax:
CURRent:PROTection:MODE? [CH1|CH2|CH3]
To Next Page
Loading...
Need help?
General
