Johnson J10RSRD User Manual

FUEL SYSTEM TESTS
Primer Solenoid Tests
Functional Test
STEP 1
Start engine and allow it to reach normal operating
temperature. Set engine speed at
2000 RPM.
While engine is running, push in key. Engine
should run richly and drop 1000 RPM . Stop
engine.
DRC6140
Results:
•
Outboard slows approximately 1000 RPM,
primer circuit is functional.
•
No affect on speed, make sure primer solenoid
activates and valve of primer solenoid is open-
ing. Proceed to next step.
STEP 2
Remove primer hose from intake or carburetor fit-
ting. Connect a
1/8 in. I.D. clear vinyl hose
between the fitting and a syringe,
PIN 346936,
filled with isopropyl alcohol. Press lightly on the
syringe.
Results:
FUEL SYSTEM
FUEL SYSTEM TESTS
• Fluid moves through passage, it is clear.
• Fluid does not move through passage(s), or
excessive restriction exists,
clean carburetor or
manifold fittings with Nipple Cleaning Tool,
PIN 326623, and retest.
Cleaning Tool 6784
Solenoid Winding Test I
Test the solenoid windings with an ohmmeter cali- •
brated on the low ohms scale. Connect meter
leads to solenoid leads. Meter should indicate:
Solenoid Resistance
5.5
± 1.5 ohms
143

Johnson J10RSRD Specifications

General

Brand	Johnson
Model	J10RSRD
Category	Outboard Motor
Language	English